
Open now · 24 hours, 7 days
Southwick Tyre Pressure Sensor Faults Found and Fixed
A warning light on a cold Mile Oak morning may only need air, and if it stays lit, the faulty sensor is traced and replaced at the car.

- On siteHome, work or roadside
- 24/7Every day of the year
- 10,000+Tyres in stock
- 5+ yrsOn the road
Can a faulty tyre pressure sensor be replaced at my home in Southwick?
Yes. After checking all four pressures, the fitter reads every sensor to find the one that has gone quiet. Pass on the registration before the visit so a matching sensor is brought, since no van can hold every type. Once fitted, the sensor is coded to the car if it needs it, and the warning is cleared. Expect a straight answer on timing when you book.
Cold drives, plug-in cars and pressure warnings

Picture a hybrid parked overnight on a drive in Hillside or Southwick Green after a clear, frosty night. Cold air takes up less room, which means by morning every tyre can sit a little under the warning threshold, and the light comes on before the car has moved. That alone is not a fault. Set the pressures to the values printed inside the driver's door, drive a short distance, and if the warning clears, the sensors are doing their job.
More cars on these drives now rely on that warning. There are 237 fully electric cars and vans among the local plug-ins, and on a like-for-like basis, plug-in numbers have grown 177% since June 2023. Those cars are heavy, so a tyre running a few psi low carries extra load and wears faster, which makes an accurate sensor worth more. Any of them registered new since November 2014 had to leave the factory with TPMS, whatever the fuel.
If the light stays on with the pressures right, or blinks for a while at start-up and then stays on, the system itself has a problem. On direct systems each wheel has a sensor behind the valve, with a sealed battery that eventually runs down and a valve that can corrode, and salt from winter roads or the sea air along the coast road can speed that up. Indirect systems use the ABS wheel speeds and have no sensor to replace. The fitter reads each wheel at the kerb, swaps the silent sensor and relearns the system.
Before you ring about a TPMS light
- On a frosty morning, check pressures cold before your first drive, using the handbook values for the load you carry.
- Running winter tyres on a second set of wheels? Mention it, as those wheels need their own sensors to stop the warning.
- Watch the dash at start-up: a steady light usually points to a low tyre, a blinking one to a system fault.
- Parked near the harbour? Look at the valve stems for white or green crusting, an early sign of corrosion.
Electric and plug-in cars in Southwick
- 349Plug-in cars and vans nearby
- 237Of which fully electric
- +177%Plug-in growth since June 2023like-for-like neighbourhoods
- 7,106Licensed cars nearby
- Plug-in share of all vehicles
- 4.0%
Vehicles: DVLA and DfT licensing statistics, June 2026, for the 10 neighbourhoods within about 1 km of central Southwick.

How TPMS sensor replacement works
Step 1: Check the pressures
Use a gauge on all four tyres. If the warning returns after inflating, suspect a puncture or a sensor fault.
Step 2: Call with your registration
So we can bring a compatible sensor or valve for your car.
Step 3: Fixed and reset
The fitter replaces the faulty part, sets the pressures and resets or relearns the system where your car needs it.
Indirect systems use the ABS sensors and usually need a reset rather than parts. Pricing: you get a clear quote on the phone before we set off, with no hidden fees. More about TPMS sensor replacement
Read next
More tyre services in Southwick
Map and coverage for Southwick · Postcodes: BN42, BN43 · Also covering: Kingston Buci · Car parks: work depends on the operator's rules and on the car being parked legally and safely
TPMS Sensor Replacement in Southwick: questions
Still unsure? Call 07356 062568 any time, day or night.
My electric car's pressure light comes on after cold nights on the drive in Eastbrook. Is that a fault?
Not necessarily. Tyres lose pressure as the temperature falls, so after a cold night outside the car can wake up just under the trigger point. Pump all four up to the handbook value. Should the warning survive a short drive, or come back within days with correct pressures, one sensor may have failed, and it can be checked on the drive.
My MOT is due soon with the TPMS warning showing. Can it be fixed at home in Southwick first?
Yes. On cars first used on or after 1 January 2012, a pressure monitoring system that is malfunctioning or obviously not working counts as a major defect at the test. A warning caused only by a soft tyre is another matter, so top up first. If a sensor has failed, it can be traced, replaced and the system reset on your drive ahead of the test date.
New tyres went on last week and now the pressure warning will not go out. What happened?
A sensor may have been cracked as the tyre went on, the valve bent, or the system not relearned afterwards. Some cars need a tool to pair the sensors again after tyre work, so the light stays on until that is done. The fitter can read each wheel's sensor at your home, replace any damaged one and complete the relearn.
TPMS Sensor Replacement in Southwick, day or night
07356 062568Call or WhatsApp 07356 062568 with your location and registration. We will tell you what we can bring and a realistic arrival time.
Get in touch
Send your details and we will call you back about TPMS sensor replacement in Southwick. For the fastest help, call.