
Open now · 24 hours, 7 days
Tyre Pressure Sensor Faults Fixed in Portslade
The pressure light keeps coming back though every tyre looks fine: each sensor is tested at your car, the dead one replaced and the system reset.

- On siteHome, work or roadside
- 24/7Every day of the year
- 10,000+Tyres in stock
- 5+ yrsOn the road
Can a tyre pressure sensor be replaced at home in Portslade?
Yes. The pressures are checked first, then each sensor is read with a diagnostic tool to find the one that has failed. Sensors vary between makes and models, so send the registration before the visit and a compatible part can be brought, since the vans cannot hold every type. Once fitted, the sensor is coded to the car if required and the warning switched off.
When the pressure light won't go out in BN41 and BN42

The light comes on during a cold start, you top up all four tyres, and two days later it is back. Or it flashes for a minute after the engine starts and then stays lit. A steady light usually means a tyre is low, while that flashing pattern on many cars signals a fault in the system itself, such as a sensor that has stopped reporting. Adding more air will not clear that kind of warning, however many times you try.
On the latest licensing figures, 4.5% of local vehicles are plug-in cars or vans, and 490 of them are fully electric. Those heavy cars put a lot of load on each tyre, so a sensor that has gone silent can leave a soft tyre unreported. Pressure monitoring has been fitted to all new cars since November 2014, which means most petrol and diesel cars of the last decade parked around Portslade have a system too, and any of them can develop the fault.
Direct systems put a sensor in every wheel, often combined with the valve, and each runs on a battery that cannot be swapped and eventually dies. Corrosion or a heavy-handed tyre change can also crack one. The fitter tests every wheel, replaces the failed sensor on the drive or at the kerb and relearns it to the car. An indirect setup works without wheel sensors, so its warning usually needs correct pressures and a reset.
How to work out why the warning is on
- Light on after a frosty night in Mile Oak? Set every tyre to the door pillar figure first, then see if it clears after a short drive.
- Before you call, see if the light glows steadily or blinks at start-up. That helps tell a low tyre from a sensor fault.
- Warning appeared straight after new tyres went on? Mention it, as a sensor or its valve could have taken a knock during the fitting.
- MOT coming up? A faulty system can fail the test on cars first on the road from 2012, so clear a lingering warning before the booking.
Electric and plug-in cars in Portslade
- 678Plug-in cars and vans nearby
- 490Of which fully electric
- 12,186Licensed cars nearby
- Plug-in share of all vehicles
- 4.5%
Vehicles: DVLA and DfT licensing statistics, June 2026, for the 18 neighbourhoods within about 1 km of central Portslade, excluding neighbourhoods dominated by fleet or lease registrations.

How TPMS sensor replacement works
Step 1: Check the pressures
Use a gauge on all four tyres. If the warning returns after inflating, suspect a puncture or a sensor fault.
Step 2: Call with your registration
So we can bring a compatible sensor or valve for your car.
Step 3: Fixed and reset
The fitter replaces the faulty part, sets the pressures and resets or relearns the system where your car needs it.
Indirect systems use the ABS sensors and usually need a reset rather than parts. Pricing: you get a clear quote on the phone before we set off, with no hidden fees. More about TPMS sensor replacement
Read next
More tyre services in Portslade
TPMS Sensor Replacement nearby
All areasMap and coverage for Portslade · Postcodes: BN41, BN42 · Also covering: Mile Oak · Car parks: work depends on the operator's rules and on the car being parked legally and safely
TPMS Sensor Replacement in Portslade: questions
Still unsure? Call 07356 062568 any time, day or night.
My electric car's pressure light came on after charging overnight on the drive in BN42. Is a sensor faulty?
Plugging in has no effect on tyre pressure. A cold night, though, cools the air inside so the pressure falls. Set all four to the handbook value and take a short drive. If the warning clears, it was simply low pressure. If it returns with the tyres correct, or flashes before staying on, a sensor test will show which wheel is at fault.
The TPMS warning came on right after new tyres were fitted on my car in Portslade Village. Why?
Either a sensor or its valve was damaged while the tyre was changed, or the system was not relearned afterwards. Some cars clear the light on their own after a few miles, so try that first with the pressures set correctly. If it stays on, the fitter can check each sensor is reporting, replace a broken one and complete the reset.
My older hatchback has an indirect system. Will it need new sensors?
No. An indirect system works out pressure loss from the wheel speed readings, so there are no sensors in the wheels to replace. A warning normally means a tyre is low, or the system needs resetting once the pressures are right, usually through a button or the car's menu. If it still will not clear, a wheel speed fault is a job for a garage.
TPMS Sensor Replacement in Portslade, day or night
07356 062568Call or WhatsApp 07356 062568 with your location and registration. We will tell you what we can bring and a realistic arrival time.
Get in touch
Send your details and we will call you back about TPMS sensor replacement in Portslade. For the fastest help, call.