Mobile Tyre Fitting Today
Open 24/7 07356 062568
Close-up of a car tyre tread pattern and sidewall

Open now · 24 hours, 7 days

Alton Puncture Repair: Patch or New Tyre?

Losing air after a screw or a hard hump? The tyre is stripped and checked inside, so you get a straight answer: repair or replace.

  • RAC Accredited Repairer
  • On siteHome, work or roadside
  • 24/7Every day of the year
  • 10,000+Tyres in stock
  • 5+ yrsOn the road

Can a puncture be repaired at my house in Alton, or will I need a new tyre?

Often it can be repaired. The fitter strips the tyre from the wheel to check the inside, because damage from running low hides there. Only holes in the middle band of the tread qualify for a repair. Damage nearer the edge or in the sidewall means a new tyre, fitted from the van when your size is aboard. Ring for a realistic arrival time.

Repair or replace: what decides it in Alton

BMW 1 Series with a new tyre ready to fit at the kerb

The first decision is whether to keep driving. A slow leak that drops a few psi a day can be topped up to reach somewhere safe to wait, but a tyre that is visibly flat or flapping should only creep at walking pace to the first spot where stopping is safe. The further it runs flat, the smaller the chance of a repair, because the inner wall gets crushed and creased between the rim and the road surface.

Where the damage sits usually tips the answer. Kerridge Industrial Estate and building sites anywhere in town can shed screws and nails, which tend to end up in the central tread and are often fixable if caught early. Kerbs and humps cause the other kind. The 21 traffic-calming features mapped around town are not many, but a hump or chicane taken briskly can pinch the sidewall against the rim and cut the shoulder, which no patch can put right.

Should a tyre fail on the A339 Basingstoke Road, mapped with a 40 mph limit, slow down with the hazards on and stop at the first safe place, such as a side street with legal parking, without driving further on the flat. On Caker's Lane, with its 60 mph stretches, pull fully off into the first lay-by or side turning clear of traffic rather than halting on a bend or a narrow verge. Stay away from the carriageway, then ring with the tyre size and say how far the car was driven after the tyre went soft.

How to make the repair-or-replace call easier

  • Leave a nail or screw in place. Pulling it out lets the air rush out and can tear the hole beyond repair size.
  • After striking a hump or kerb hard, check that tyre's pressure each morning for a few days before deciding it survived.
  • Note roughly how far you drove once the tyre felt soft. That distance often decides whether a repair is still possible.
  • Take the town's speed humps at a crawl and square on, so the sidewall is not squeezed between the hump and the rim.

What tyres face on the roads around Alton

  • 102.7 kmRoads mapped (carriageway)
  • 21Traffic-calming features (humps, cushions, chicanes)
  • 23,923Busiest road with DfT data (A31)vehicles a day · 2025 DfT estimate, 1.7 km from the centre
Industrial estate
Kerridge Industrial Estate

Traffic: DfT annual average daily flow (A31). Roads and places within 2.5 km: © OpenStreetMap contributors.

Flat tyre on a steel wheel at the roadside

How a mobile puncture repair works

  1. Step 1: Inspected inside and out

    The tyre comes off the wheel. Damage you cannot see from outside often decides whether a repair is safe.

  2. Step 2: Repaired if it is safe

    A hole in the central repairable area, within the British Standard BS AU 159 limits, is repaired from the inside.

  3. Step 3: Replaced if it is not

    Shoulder or sidewall damage, a hole that is too large, or a tyre driven flat means a new tyre instead.

Run-flat tyres follow the tyre maker's own guidance, so some cannot be repaired. Pricing: you get a clear quote on the phone before we set off, with no hidden fees. More about puncture repair

Read next

Map and coverage for Alton · Postcodes: GU34 · Also covering: Chawton, Farringdon, Binstead, Four Marks, East Tisted · Car parks: work depends on the operator's rules and on the car being parked legally and safely

Puncture Repair in Alton: questions

Still unsure? Call 07356 062568 any time, day or night.

07356 062568

There's a screw in my tyre after a visit to Kerridge Industrial Estate. Repair or replace?

That turns on the exact spot and on what the inside looks like. A screw sitting centrally in the tread, with no crushing inside from driving low, is usually a candidate for repair. Close to the edge of the tread, or with marks on the inner lining, the tyre needs replacing. The fitter shows you what was found before doing either.

My tyre went flat on Caker's Lane and I drove home on it. Can it still be saved?

Possibly not. Even a short run on a flat can crease the inner lining and weaken the sidewall, and that only shows on the inside once the tyre is stripped. The fitter checks it inside first. If the structure has been harmed, a new tyre goes on instead, so keep the size from the sidewall handy when you call.

Can I leave a slow puncture until the weekend if I only drive around town?

It is a gamble. A slow leak can become a flat without warning, and every mile at low pressure heats the tyre and weakens it, which can turn a fixable puncture into a replacement. Topping up buys a short, careful trip at most. Having it looked at early keeps a repair on the table.

Puncture Repair in Alton, day or night

07356 062568

Call or WhatsApp 07356 062568 with your location and tyre size. We will tell you what we can bring and a realistic arrival time.

Get in touch

Send your details and we will call you back about puncture repair in Alton. For the fastest help, call.

Send an enquiry

Printed on the side of your tyre. Not sure? Leave it blank and we'll check when we arrive.

Stranded right now? Calling is fastest: 07356 062568.

Call nowWhatsApp