Mobile Tyre Fitting Today
Open 24/7 07356 062568
A fitter crouched beside a silver car, inflating a tyre from a compressor

Open now · 24 hours, 7 days

Aylesford Tyre Pressure Sensor Faults Fixed at Home

Warning light stuck on after a cold start or new tyres? The fitter reads each sensor, swaps the failed one and resets the car on your drive.

  • RAC Accredited Repairer
  • On siteHome, work or roadside
  • 24/7Every day of the year
  • 10,000+Tyres in stock
  • 5+ yrsOn the road

Can a faulty tyre pressure sensor be swapped at home in Aylesford when the light stays on?

Yes. Pressures are checked first, then every sensor is read with a diagnostic tool to find the one that has failed. Sensors are made to suit particular cars, so text or call with your registration and the correct type can be brought, or you will be told if it must be ordered. The new part goes in, is coded to the car if required, and the light is cleared there and then.

Pressure warnings on newer cars around Aylesford

Volvo XC90 on a block-paved driveway during a mobile tyre fitting

The amber horseshoe symbol appears on the dash as you set off, and you are not sure if a tyre is going flat or the system is playing up. Often it comes on overnight in cold weather, because the air in each tyre contracts as it cools. If the light clears after the tyres are pumped to the right pressure, that was the cause. If it refuses to clear, or blinks before settling, a sensor is the likelier fault.

More cars here carry these systems every year, as older cars give way to newer petrol, hybrid and electric models. Drivers in Eccles, Forstal and the old village who commute on the M20 put steady miles on these systems, and a sensor that has done years of motorway runs and winter salt is more likely to fail. Most are recent enough to have TPMS as standard, since it became compulsory on new cars from November 2014. Their weight also loads each tyre harder, so a low reading on an EV is worth a proper check.

Many of these cars use direct sensors inside each wheel, behind the valve, powered by sealed batteries that wear out over time. A sensor can also be cracked by a rushed tyre change or seized by corrosion after a few winters of road salt. The fitter comes to your drive or workplace, tests each wheel, replaces the faulty part and relearns the system. Get it done before the MOT, where a faulty system is a major defect on cars first used from 2012.

How to tell why the pressure light is on

  • Pump each tyre to the figure in the handbook or door frame first, then drive a mile or so to let the system update.
  • Notice whether the symbol is steady or flashes first. A flash on start-up usually means the system has a fault.
  • Light came on just after a tyre change at another garage? Ask them if the system was relearned once the job was done.
  • If the warning returns every few weeks on a car with direct sensors, a sensor battery may be close to the end.
Newly fitted tyre on a silver Volkswagen

How TPMS sensor replacement works

  1. Step 1: Check the pressures

    Use a gauge on all four tyres. If the warning returns after inflating, suspect a puncture or a sensor fault.

  2. Step 2: Call with your registration

    So we can bring a compatible sensor or valve for your car.

  3. Step 3: Fixed and reset

    The fitter replaces the faulty part, sets the pressures and resets or relearns the system where your car needs it.

Indirect systems use the ABS sensors and usually need a reset rather than parts. Pricing: you get a clear quote on the phone before we set off, with no hidden fees. More about TPMS sensor replacement

Read next

Map and coverage for Aylesford · Postcodes: ME20 · Also covering: Eccles, Ditton, New Hythe, Burham, Snodland, Holborough, Wouldham, Halling · Car parks: work depends on the operator's rules and on the car being parked legally and safely

TPMS Sensor Replacement in Aylesford: questions

Still unsure? Call 07356 062568 any time, day or night.

07356 062568

My EV's pressure warning came on after charging overnight on the drive in Eccles. Is the charger to blame?

No, plugging in does nothing to the tyres, but a frost can. Cold air shrinks, so one tyre may sit just under the trigger point at dawn. Top every tyre up to its proper figure and take a short drive. Should the symbol stay lit after that, the fitter can test each sensor on the drive.

The pressure light flickers on and off on my commute along the M20. What does that mean?

A sensor with a weakening battery or a damaged valve can lose contact with the car now and then, so the warning comes and goes. Check the pressures first. If they are right and the flicker carries on, the fitter can read each sensor in turn to find the weak one and replace it with a part matched to your registration.

I have new tyres booked in Aylesford. Will the sensors need replacing at the same time?

Not always. The valve seals on direct sensors wear and can corrode, so they are inspected when the tyres come off, and the system is reset afterwards where the car needs it. If a sensor is faulty or its battery is low, it can be replaced on the same visit, provided the right part has been arranged from your registration.

TPMS Sensor Replacement in Aylesford, day or night

07356 062568

Call or WhatsApp 07356 062568 with your location and registration. We will tell you what we can bring and a realistic arrival time.

Get in touch

Send your details and we will call you back about TPMS sensor replacement in Aylesford. For the fastest help, call.

Send an enquiry

Printed on the side of your tyre. Not sure? Leave it blank and we'll check when we arrive.

Stranded right now? Calling is fastest: 07356 062568.

Call nowWhatsApp